Announcement Module

How To Post Images

Want to know the how to upload images to your posts? Image Posting Tutorial
See more
See less

JP0610 Jointer

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • JP0610 Jointer

    I just finished assembling my Jointer and I couldn't be more pleased with its performance. Smooth cuts, etc. This is my first jointer so I have a question. I'm jointing and planing some narrow stock, no more than 2" wide. it occurs to me that over time I will be moving stock over the same part of the blade, that small section next to the fence. Should I plan on moving the fence over to vary the cut so that the blade does not wear down in that spot only?

  • #2
    Hi glad you are enjoying the jointer . Yes you should move the fence remembering to check that it is still at 90 degrees to the table . Good luck Anthony