Announcement Announcement Module
Collapse
No announcement yet.
Ts3650 Micro Adjust Lever Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ts3650 Micro Adjust Lever

    I'm quite the newbie at this and I am doing some fine tuning on my 3650, this being my first TS and all, I was a little confused when the book mentions a micro adjusting lever in the rear of the table saw. It makes sense to me, but I have no idea where to look for it or what it even looks like. If anyone can help locate this I would be grateful.

  • #2
    Welcome to the forum.
    It is a lever about 3 inches long. You will see it above the motor, sticking out from under the table top a bit.
    ken
    Poplar Branch Wood Crafts

    Comment


    • #3
      Thanks for the advice, I finally found it. After loosening the bolts enough it kind of hit me in the face. I did not realize that it was going to be flat against the saw. After I found that it took me a few tries to adjust it, but I got it almost dead on.

      Comment

      Working...
      X