If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You will be required to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
MAINTENANCE NOTICE: The site will be down for extended maintenance on Sunday, October 2, 2016, between 12 Noon and 6 PM Eastern. We apologize for any inconvenience!
i have managed to drip the cutting oil on some new concrete. i have tried to remove the stains with the obvious methods like degreaser, bleach, pressure washer, and a few other chemicals. nothing works.
floor dry/ oil dry, sold at auto parts stores and some hardware stores,
is it a clay based and it seems to pull the oil out of the concrete, it may take some time, but where I have spilled oil in the shop and cover with floor dry, the spot seems to be gone in time,
it is probably know by many names,
the finer it is ground up the better it will absorb the oil out of the concrete.
Push sticks/blocks Save Fingers
"The true measure of a man is how he treats someone who can do him absolutely no good."
attributed to Samuel Johnson
PUBLIC NOTICE: Due to recent budget cuts, the rising cost of electricity, gas, and oil...plus the current state of the economy............the light at the end of the tunnel, has been turned off.
Thre was a product available years ago called "K2R Spot Lifter". It was for taking stains out of clothes. I was never successful removing even a single stain with it. But it was the best at sucking oil out of wood, concrete, or just about anything else. Haven't seen it in years.. wonder if it's still available? It might leave a light ring on your concrete, though... but as I remember, that usually faded away.
Lacking the K2R, did you try a steel wire brush and copious amounts of lacquer thinner?
Mineral spirits or naptha (aka lighter fluid, coleman lantern fuel, charcoal starter) to fully wet the area and immediately cover it thickly with dri-zit, kitty litter, etc (grease absorbant clay). Grind it in with a stiff broom or even your boot sole and let dry. Sweep up after about 15-30 minutes and redo if its not all gone. May need to let it set longer if the concrete is moist, humidity is high, or temp is low.
I have used it on transmission fluid, brake fluid, and oil with great results.
If there is a thin residue outline, then use detergent soap and again dry it with the absorbant.
Haven't heard that trick in a long time. But I was taught to use a piece of old concrete block to do the grinding of the oil dry material. Both should work as each would grind the material into a fine powder. David