Re: Jessem Mite-r-slide and TS3650 ?
Hi Mike. Welcome to the forums!
*insert limited knowledge warning here* (Just a warning that I don't know a whole lot, but I'll share what I do know!).
I would think you could bolt that to the left-side wing by lining up and drilling some holes, most likely. Unfortunately, I'm doubtful the length of the mitre arm would be long enough to compensate for that distance from the blade. In other words, there'd be too much table between the Jessem and the blade.
Another thing to watch for is when lining up the Jessem to attach, you have to make sure the bolt holes won't go where the webbing is on the underside of the cast iron. You have to be able to drill through the "thinner" part of the cast iron on the edge.
I put it all back together better than before. There\'s lots of leftover parts.