i'm curious to know what caused the line to squeeze at those 2 locations?
i've done plenty of lines with 45's and sdr17 is real tuff stuff. you can hit it with a sledge hammer and not damage it
in fact when i'm finished and run a camera through, you can't even see where the 45 was.
the 45's are turned into real long radius sweeps.
was there anything in the ditch that was pressing on these 2 bad spots? I dug, as you can see, around the pipe, nothing was in the way, pressing the pipe,
is it possible that this was a 90 and not a 45 bend? I believe there was possibly a comby there. I found some of it
you have a 45 and 22 to bring it together. Unable to get a 1/4 bend to work properly, was barely able to get the 1/8th and 22 to work.
i've done as many as 3 -45's on 1 pull. I too have pulled through 1/8 bends and even 1/4 bend's, no problem.
what happened to the original installer? I am sure the new owners will be in contact with you. Kidding, not sure, no one knows who did the installation...these are new owners, I am sure they will contact the previous owner.
nice photos thank you, can't wait for you all to see the video!!!
I guess I have to add more, so it will post It said my message is to short.