New member and I really look forward to getting to know ya! I have been assembling my TS3660 and came across a problem with an adjustment in the instructions.
To Install Back Rail:
Insert square head bolts (5/16-18 x 1 in.) into the holes
on the back of the saw table and extension tables.
Attach flanged hex nut (5/16-18) loosely allowing the
square bolt head to protrude.
Slide the back rail slot over each of the square head bolts
and finger tighten the four nuts.
Place a framing square on either side of the blade. Move
the back rail right or left until the indicator mark is aligned
with the framing square. Finger tighten the nuts.
What indicator mark are they referring to?
I have to say this is a well put tiger Table Saw, I and very impressed with the packaging and the fit and finish of the the saw.
I had one problem with starting it up. Had to chase the electrical problem to where the cord goes in the motor. Seems the wire nut were not connecting. Other than that, I have had a problem free Assembly.