Finally getting to setup the TS3612 after doing a lot of prep work in the shop... Everything is going smoothly (Herc-U-lift was...interesting!) but I have a question on the spacer bar.
(FYI: I needed just 2 shims in the back right wing to tie the rear guard).
I go to install the spacer bar and I'm following the directions to move the spacer bar all the way against the wing, I look if I need a shim (one is needed).
I put one shim in and the spacer bar is nice and snug but as soon as I start turning set screws, the spacer bar spreads the guide bars ever so slightly so that now the shim is loose and it looks like it adds space for 1 or 2 more shims.
Should I worry about this? Am I neetpicking? Am I not understading the directions clearly enough? (I did double check that the locking plate assembly was in the right direction).