Re: What Ridgid Fence for my Craftsman Table Saw?
FTR, the ts 2412, 2424, 3612, 3650 and 3660 would all accept the ac1036:
Originally Posted by Bob D.
Pressing Technology - RIDGID Professional Tools
it's purpose was to provide the same 36" right side rip capacity as the 3612, 3650 and 3660 (so for these actual saws, it was pointless). it worked well and i have one on my 2412 (closeout from HD for $20):
as to the OP's fence question, the fence system (fence and rails) of the 3612/3650/60 will also fit the c-man. those three parts can be purchased from m&d mower for around $325 plus shipping:
TH1019 - TH1019 RYOBI-RIDGID TOOLS PART TH1019 - RIP FENCE ASSEMBLY - TTI-TH1019 - RYOBI/RIDGID TOOLS
TH100056 - TH100056 RYOBI-RIDGID TOOLS PART TH100056 - FRONT RAIL - TTI-TH100056 - RYOBI/RIDGID TOOLS
TH100057 - TH100057 RYOBI-RIDGID TOOLS PART TH100057 - REAR RAIL - TTI-TH100057 - RYOBI/RIDGID TOOLS
i also have a similar c-man with a delta t-2:
on a value basis, the t-2 will be the easiest non-OEM fence to adapt to the TS, cost the least (absent a CL deal) and perform VERY well. since mine is a 30" model, i can say that, with a little bit of shifting, it could easily be set up for 36" of capacity.
if it was me, absent a CL deal, i'd get a t-2 from here:
Delta 36-T30 30" T2 Fence System
regarding CL, just saw this:
you never know what's out there unti you look. good luck.
Last edited by FINER9998; 06-25-2011 at 01:03 PM.
there's a solution to every problem.....you just have to be willing to find it.