Hello gents and any ladies.
I recently finished setting up my saw and love the cuts. This forum was very helpful as I check it nearly every day for past few months, however have not had much reason to post.
But.....I have been given a table saw guard, HTC 10A-L Brett gaurd (call it luck). It requires an aftermarket splitter but I don't know of any that fit the TS3650. I was thinking I may have to alter the OEM splitter/guard to fit my needs. The Brett guard is the same one used by Kelly Mehler in his video (if I'm correct, looks like it). His saw has the Delta-only splitter on it from what I've researched.
Any ideas or push towards the right direction would be helpful.