Two things come to mind. Are you applying downward pressure to the stock on the outfeed side of the cutter head? Is your outfeed table set correctly?
I saw a neat trick on how to adjust the outfeed side of your jointer the other day. What you do is lower the outfeed table so that its lower than the cutter head. Run a piece of stock far enough so the jointed end is over the lowered outfeed table. Shut the jointer off and adjust the outfeed table height up to the jointed edge of the stock.
As long as you don't change the infeed table height, the jointer should stay perfectly aligned.
Last edited by BadgerDave; 01-17-2006 at 09:30 AM.
111,111,111 = 12,345,678,987, 654,321