Replacement Mitre Gauge for TS 2400
I've had my 2400 for about 2 years, and just love the damned thing. It's very hard to find anything to fault, except that there's a bit of slop between the mitre gauge and the slot. SO, I'm wondering if any of you guys have bought aftermarket mitre gauges for your 2400's, and what your experiences have been. There's so much out there, it's tough to figure the best way to go. This is a hobby for me, and most of the work I do are small projects, so precision is important. Any input would be appreciated.
Don't really need a new one!
In "The Table Saw Book" by Kelly Mehler, he describes how to take the slop out of your miter gage.
You use a prick punch to make a series of dimples on both sides of the bar. If it gets too tight, you file down the dimples. If it's still too loose, you make bigger dimples. HTH:)