New saw blade burning material
Hi all, I just installed a new blade on my TS 3650, Freud LU84R011 10" x 50-Tooth Combination Blade, to replace the factory blade.
My problem is that this new blade seam to burn the wood or plywood if I happen to not keep the piece moving as I rip or crosscut.
I feel it is impossible to have the piece in constant motion, as you need seconds to ajust your hands to make sure you have proper grip on the wood.
Is this normal?, I am working with Pecan and I am trying to build a L shape desk.
My workaround so far is to cut the pices 3/32 bigger and then run the piece again using my jointer to take the burns out.
Any comments, suguestions would be appreciated.