My 1976 Rockwell table saw finally went "belly up" and is not worth the cost to have the motor rewound. I'm looking at the Ridgid 3650 and the Delta 36-980 (at Lowe's).
I've read most of the postings here relating to the 3650 as well as a couple of evaluations from woodworking publications. Without question, it is an excellent piece of equipment. My problem is that I cannot find any evaluations on the Delta to compare and make a competent decision.
I make pieces of furniture occasionally as a hobby - mostly from cherry, laminates and occasionally, pine. Any comments, recommendations, suggestions or experiences would be greatly appreciated.