PLUMBER RICK
Senior Member
Last Activity: Today, 01:32 AM
Joined: 08-15-2004
Location: LOS ANGELES
-
My concern is if the drive shaft connection is going to take all the misaligned drill users. Meaning by having a hand held drill, you're not always applying... -
i've done hundreds of whacking jobs. not 1 person has ever complained that i use a drill or the cable lays on the ground and i wind it up.
...Leave a comment:
-
correct. the exhaust would have to have been vented through the floor. instead of outside, the cooling air is required, hose reel is manual and need to...Leave a comment:
-
Vent 90s are not legal on a waste line. Why would they bother to design a machine to address illegal installations?
a 100' shaft that is...Leave a comment:
-
Our ring cameras pick up the neighborhood cats and dogs coming to the door at night time. But more recently, the neighborhood skunk. Never knew we had...Leave a comment:
-
My Rick Whacker is right around $200.00 without the $99.00 drill motor.
100' of 3/8" cable that spins both ways and cuts out roots like...Leave a comment:
-
Here's the issue with bolt cutters. Remember doing new construction for 15+ years, i set thousands and thousands of toilets. cutting bolts was a simple...Last edited by PLUMBER RICK; 02-19-2019, 02:32 AM.Leave a comment:
-
technically a jetter is a pressure washer. The jetter will usually have a pulsation mode that will cause the hose to vibrate and break the hose friction...Leave a comment:
-
The smaller jaws are about $165.00 each. not a huge investment. But limited to 1/2'' and 3/4'' only. too bad it's not able to do 1''.
R... -
Actually all the first generation smaller press tools can press steel/ mega press 1/2" and 3/4".
Of course the larger tools can...Leave a comment:
-
didn't have the room for the spring return 50' high pressure or fill hose reels. No big deal. I keep my original 300 x 3/8'' jetter hose, 100' x 3/8''... -
yes they do. i have a couple and it's the best quality pelican knock off I have seen. My dji mavic drone fits perfectly inside with the foam compartments.... -
Could this be the Ridgid Whacker? Possibly?
https://twitter.com/RIDGIDtoday/stat...78766171521024
Rick....Leave a comment:
-
I blame the repair shop, not Ridgid.
Rick.Leave a comment:
-
An oscillating cutter will shake the heck out of the bolt and loosen the nut. They also make brass closet bolts that are pre scored that will allow you... -
I use a small hacksaw called a tiny tim. Have cut 10k plus bolts this way.
You could try using the nylon bolts or the real expensive self...Leave a comment:
-
owning multiple different models of seesnake cameras, the best pushing cable would be from the rm200 with the thicker D2B drum. it's 165'. The outer cover...Leave a comment:
-
Pretty simple as you're only keeping the lower power control box. It has a video out RCA Jack. You're not using the VCR anymore are you?
...Leave a comment:
-
i would think that if it's been reported stolen and serial numbers were reported, then the factory service would have a record of it in their system....Leave a comment:
-
Sitting on 2 brand new color self leveling heads. A mini and a full size.
Plus a new 200' color full size and a brand new 325' black and...Leave a comment:
No activity results to display
Leave a comment: