drainman scott
Senior Member
Last Activity: Today, 09:57 PM
Joined: 03-31-2019
Location: Northern, Massachusetts
-
Not sure about shipping internationally.... https://www.directtoolsoutlet.com/ .... you could call them and find out.... right now there charging... -
Is the shower trap water level the same height as the toilet drain water level..... you could try running water down the toilet drain on the slab... if... -
Your right... I should of known better I been using Eels for over 30 years. -
Here in Mass there is 1 base available for pickup that's it .... ( but if you look at the questions and answers they have complained about there limited...Leave a comment:
-
Looking at my K-50 5/8" cables they are wound opposite than Eels so running them counterclockwise would back them out which would make sense. -
1 1/4 " Eels are right hand wound so rotating them counterclockwise drives them in.... Ridgid sectional cables I assume are left hand wound? causing...Leave a comment:
-
You might have a bad seat causing the leak on your Sillcock... if that's the case your better off matching it up and replacing the whole Sillcock. If...Leave a comment:
-
This picture I got off another forum..... it's a R4330 planer if this looks like the pulley you have on your TP1300 I would think you would...Leave a comment:
-
Leave a comment:
-
The pulley I believe your referring to part number 827789 motor pulley is threaded on note it's a reverse thread.Leave a comment:
-
My R4331 chain has some slack to it ..... it sags to about to the bottom of planer... I got it attached to a Ryobi miter saw stand and the mounting brackets...Leave a comment:
-
You could try pulling it off the shaft..... in the picture I have a plumbers faucet handle puller attached to the shaft of the drum sander...Leave a comment:
-
My R4331 in order to make an adjustment I would need to remove chain that is moves cutter head up and down on the threaded post in sync. and then...Leave a comment:
-
Leave a comment:
-
I'll be checking the K-309 out March 7 at PHCC trade show in my state...... Ridgid has a booth there... but we will all know more after there introduction...Leave a comment:
-
In order to get the LSA you have to register in 90 days but all ( new ) and ( blemished ) Ridgid tools carry a automatic 3 year warranty. nothing needs... -
There is a 3 year warranty on both tools the head and base if you have the receipt call RIDGID customer service if you don't have receipt they will ask...Leave a comment:
-
This is my planer with a level at the cutter head and bed there about the same.... is this where yours is off 1/4" ?...Leave a comment:
-
According to Dun & Bradstreet a company analyst firm Ridge Tool Company employees 1,500 in all its locations, with it's main headquarters locate in... -
...
Leave a comment:
No activity results to display
Leave a comment: