Search Result - RIDGID Forum | Plumbing, Woodworking and Power Tools

If this is your first visit, be sure to check out the FAQ by clicking the link above. You will be required to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Search Results: 4 results in 0.0039 seconds.

cwenbass replied to Metal shards in plunge router base

in Power Tool Discussion Forum

02-22-2013, 10:24 PM
Re: Metal shards in plunge router base

You have been very helpful CW. Yes they are in where the springs are. I did not try using it since...

See more | Go to post
Leave a comment:
cwenbass started a topic Metal shards in plunge router base

in Power Tool Discussion Forum

02-22-2013, 07:45 PM
Metal shards in plunge router base

Any ideas about what to do with small metal flakes in router base? I used a magnet to get most out but causing a plunge broblem.

See more | Go to post
cwenbass started a topic Centering a router on a table

in Woodworking Discussion Forum

02-20-2013, 09:09 PM
Centering a router on a table

Rigid router question. I have a rigid router and bosch table. I want to make sure the router is perfecftly centered on the table. However, no baseplate...

See more | Go to post
cwenbass started a topic Rigid Router: Setting plunge depth

in Woodworking Discussion Forum

02-20-2013, 09:07 PM
Rigid Router: Setting plunge depth

I just bought a new rigid router combo. I am unsure of how to set the depth on the plunger base.

Thanks

See more | Go to post

Previous template Next

Working...

X