Search Result - RIDGID Forum | Plumbing, Woodworking and Power Tools

If this is your first visit, be sure to check out the FAQ by clicking the link above. You will be required to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Search Results: 4 results in 0.0039 seconds.

Emesine started a topic Gasoila Hard Set

in Pipe Joining and Fabrication

11-10-2021, 12:30 PM
Gasoila Hard Set

Hello,

I'm working on a project involving 2 inch threaded stainless steel pipe. Hot water- temp from 140 to 240F. I'm having trouble with...

See more | Go to post
Emesine replied to 50 threads on 304 stainless, little pipe experience, what should I buy?

in Pipe Joining and Fabrication

04-03-2019, 02:52 PM
Thanks for the encouragement! I have a small job to do in 3/4 NPT. Maybe I'll gear up for stainless and try my luck on this small job. If things go...

See more | Go to post
Leave a comment:
Emesine replied to 50 threads on 304 stainless, little pipe experience, what should I buy?

in Pipe Joining and Fabrication

04-03-2019, 12:07 PM
OK, so if I do go stainless, make sure to buy good oil, high quality dies, and very high quality threader. Good quality dope and teflon. But you would...

See more | Go to post
Leave a comment:
Emesine started a topic 50 threads on 304 stainless, little pipe experience, what should I buy?

in Pipe Joining and Fabrication

04-02-2019, 10:33 AM
50 threads on 304 stainless, little pipe experience, what should I buy?

Hello,

I am about to start a job involving putting together a low pressure line made out of 1.5 inch 304 stainless steel for my barn. I...

See more | Go to post

Previous template Next

Working...

X