Anyone Open carry a sub 6" Fixed blade Knife ?
as a work tool ?
Announcement
Collapse
No announcement yet.
Search Result
Collapse
90 results in 0.0034 seconds.
Keywords
Members
Tags
-
Anyone Open carry a sub 6" Fixed blade Knife ?
-
anyone own the dual blade saw?
http://www.homedepot.com/p/RIDGID-5-...3250/202581823
I tried the search function and had little success.
...
-
Blade Shifting on Ridgid R4512
I recently purchased a Ridgid R4512. I put it together and made all the adjustments but I notice that when I installed the riving knife and tighten the...
-
4512 TS Blade wobbles when raising and lowering?
I noticed the other day that my blade was way out of square. I followed the directions and squared the blade to the mitre slot. Now when I raise and lower...
-
3650 90 blade
I am having trouble getting my blade to a true 90 degrees. I am afraid to crank too hard on the trunnion as I have heard of people snapping it. I have...
-
R4330 Planer Blade Replacement Question (2nd try)
Hi,
Sorry to post this again but for some reason my first post is not showing up.
So I am about to change my R4330 planer...
-
R4330 Planer Blade Replacement Question
Hi guys,
I decided to change the blades on my R4330 for the first time this week. I am not sure about a couple of things so maybe one of...Last edited by Davexc; 06-11-2013, 07:51 AM.
-
3 Blade Cutter vs Spiral Root Saw
I have a pond overflow pipe nearly clogged with grass. It is a 60' horizontal run of 8" ID double-wall poly pipe terminating in a catch basin. ...
-
R4512 Blade Alignment at 45 degrees
Hi everyone, I'm new to table saws and new to the forum, but have been following for a while. I have a new R4512 and thought I finally had everything...
-
JOBMAX blade source
CHECK OUT THE NEW & IMPROVED Fitzallblades.com
Dear Loyal Fitzall Blades Customer,
We are proud to announce our NEW & IMPROVED...
-
Table saw sticks when setting blade to 45%
When I move my Table saw blade close to 45% it sticks and gets very hard to turn. Any help is appreciated
-
craftsman molder blade #2302
I have a craftsman molder blade # 2302 and need to know the model of the craftsman molder it will fit. Will this blade fit any other brand of molder...
-
4512 Table Saw and Dado Blade Sets
Has anyone successfully mounted an 8-inch dado set on the 4512 table saw? If so, HOW?? The riving knife prohibits making a full pass over the blades....
-
Ridgid Mitre Saw, Blade stopped, motor keeps running...
Hi, My 12" mitre saw just failed... after about 10 hours of use.
At first, it sounded as if it would not get up to speed until about...
-
R4512 blade wrench does not fit
I just setup my R4512. When I went to install the blade, the open end blade wrench that goes on the inside of the blade to tighten it does not fit on...